Attached crotch strap brackets to the seat ribs Put together seat ribs 3 on each side Prepared seatback hinges. Took me two attempts. On first attempt I made them mirrored. Hope I will have enough hinges left for the rest of …
attached bearing brackets to the seat ribs L and R spend 1 hour
prepared autopilot brackets and installed the doubler on one of the seat ribs dremel toll came really handy for cutting an opening in the seat rib spend 1 hour
Prepared seat ribs assemblies – final drilled a few holes, dimpled a few bits and attached nutplates. A few holes were dimpled in the factory, however the dimples were not deep enough, so I had to go through them over …
Finished deburring of seat ribs and seat-belt attach lug components Riveted seat-belt attach lugs Flaperon mixer arm bushing has arrived. It is still a bit short. I put i thin washer and one thick washer around the bushing (instead of two …
Fuselage – Baggage floor – Seat-belt attach lugs Read more »
Preparing more parts for the baggage floor assembly. Boring stuff Seat belt brackets etc. Spend 2 hours.
Attached bearing brackets and put together pulley brackets Finished with the page 21-03 Started putting together FLAPERON MIXER ARM ASSEMBLY Found that one of the bushing is of the wrong size Asked VANs what do I do with the short …
Riveted F-1206A to the rest of the assembly along with small ribs. Attached nutplates to 1206G and 1206H and other parts of the floor. Manufactured bearing bracket angles F-1206J. these are new addition to the kit as per SERVICE BULLETIN 14-12-06 Basically have done …
Riveted the floor to the central section. attached floor ribs. Lots of solid riveting has been done today. Not many had to be drilled out and redone. Slowly but surely the baggage section is coming together. Spend 6 hours today.