Fuselage – Seat ribs assemblies

Prepared seat ribs assemblies – final drilled a few holes, dimpled a few bits and attached nutplates.
A few holes were dimpled in the factory, however the dimples were not deep enough, so I had to go through them over again.

Had a test ride for my new Cleveland Rivet Squeezer. So far so good. It has a bit awkward weight distribution, but I’ll get used to it.
Only tried it on AD3 rivets. Will see how it goes on AD4.

Also added 0.4mm shim under one end of the flaperon mixer arm bushing.

Spend 2 hours